CHARACTERISTICS MF Series
Face to face dimension
Robust 4-post topwork for maximum load and a wide variety of actuator types.
A unique transverse seal, consisting of a transverse seal profile and packing compound, makes the body bubble-tight towards the atmosphere.
The transverse seal can be repacked at any time and under full pressure using the lateral packing screws.
A mechanically retained round cord seal creates a bubble-tight shut off on the gate edge.
Optimized chest design to minimize the build-up of solids due to gate geometry.
With its optimized gate geometry, accumulated media is pushed out of the gate guide and flushed out into the bore by the increased flow.
The gate is mechanically guided over the full stroke.
In the closed end position, the gate is also mechanically supported.
All known pipe-cleaning methods (e.g., pigs, brush cylinders, etc.) can be used with the body bore, resulting in minimal pressure drops.
The non-rising stem in the manual actuator saves space and provides good mechanical power transmission.
e.g. Food waste, Household waste, Wood chips, Manure, Substrates, Other renewable resources ...
e.g. Coal dust, Mining slurry, Sinter water, Tailings, Lime powder ...
Chemical and petrochemical industries
e.g. Viscous pastes, Granulates, Bitumen/tar ...
e.g. Waste water, Rainwater, Industrial water, Mixed water ...
Coal fired power stations
e.g. Coal dust, Coal slurry, Lime powder, Flue ash ...
Pulp and paper industry
e.g. Pulp Stock (Low to high density), Liquor (black, white, green) ...
Waste water treatment plants
e.g. Waste water, Raw water, Sludge, Digested sludge, Floating sludge ...
e.g. Seawater ...
e.g. Cement, Lime powder ...
MATERIAL OF CONSTRUCTION
|Part||Cast iron||Stainless steel|
|Topwork||Carbon steel||Carbon steel|
|Stem / Piston rod||1.4104||1.4104|
Other materials upon request
|Body||2 Comp. Epoxy-Polyamide Resin Primer, 2 Comp. Polyurethane-Enamel-Top Coat|
|Topwork||2 Comp. Epoxy-Polyamide Resin Primer, 2 Comp. Polyurethane-Enamel-Top Coat|
- MF with handwheel 2D (DXF/DWG)
- MF with handwheel 3D (STEP)
- MF with bevel gear 2D (DXF/DWG)
- MF with bevel gear 3D (STEP)
- MF with pneumatic cylinder 2D (DXF/DWG)
- MF with pneumatic cylinder 3D (STEP)
- MF with electric actuator 2D (DXF/DWG)
- MF with electric actuator 3D (STEP)
- MF with hydraulic cylinder 2D (DXF/DWG)
- MF with hydraulic cylinder 3D (STEP)